Products

    All Products   

    Transducers

    Interfacing 

    Ordering 		 
 

WattsOn®-DISP - Miniature Local Display Module For WattsOn Transducer

The WattsOn-DISP provides a convenient method of displaying relevant electrical measurements. WattsOn-DISP is designed for local mounting through a panel with the included mounting hardware. The display is designed for use with WattsOn-1100 models only.
 

Features: 

  • Panel Mount
     

  • Large, easy to read Two-Line Display.
     

  • Display information customizable via RS-485 Modbus
     

  • LED Backlight

 

 

Product Description:

The WattsOn-DISP allows for local display of electrical measurements performed by the WattsOn Power Transducer. Its small size and form factor allow for an easy and clean installation through a panel with the included mounting hardware. Optionally, a NEMA 4X bezel may be provided to allow for installation in harsh environments.

The display parameters are selected by configuring the main WattsOn unit using RS-485 (Modbus). It may be used with WattsOn-1100 units (firmware 4.3 or higher).

The WattsOn transducer configured for use with the display, uses the second pulse output is used for data transmission from the WattsOn. This leaves the RS-485 port free for communication with any other RTU.

The display features a LED backlight allowing viewing in any condition.

NEW: v2.0 of the WattsOn-DISP modules support three user selectable (via rear jumper) display modes:

  1. Fixed two line display (User set registers)

  2. Push button scrolling of parameters (Two user set registers plus W, VA, VAR, PF, Frequency and kWh).

  3. Two line display, top line cycling between two user set registers plus W, VA, VAR, PF, Frequency. Bottom line fixed at kWh.

Specifications:

Power Supply:

 16-24 VDC (50mA max.)

Display:

 100 x 32 Graphic LCD
Displays two parameters in a large (10mm) font
Communication: Single Wire (plus ground) proprietary protocol from WattsOn transducer (requires WattsOn-1100 with firmware version 4.3 or greater)
Backlight: LED (yellow)
Mounting: Panel Mount ("through the door") with adjustable rear brackets
Panel Thickness 0.8 mm (min)
5.0 mm (max)
Cutout Dimensions: 40mm x 72mm
Depth ("into" the door) : 40mm
(including terminal block)
Bezel Dimensions: 44mm x 76mm

Ordering Information:

     WattsOn-DISP fully describes this product

Information:


Datasheet		 PDF

Installation Instructions		 PDF

 

copyright (c) Elkor Technologies Inc.

power meter

wattmeter

power transducer

modbus

rs485